Port-mirroring mode monitor-port (mirror-port-X /mirror-port-Y /mirror-MAC-A /mirror-MAC-B ) The port-mirroring command uses the following format: Once in the command line, you will need to enter the configuration mode by using the following commands:Įnable (command line suffix will change from ">" to "#")Ĭonfigure terminal (command line suffix will change to "(config)#") Otherwise you will need a serial cable to connect to the front of the switch with the following settings: If a switch you are connecting to has an IP address and you still chose to configure it via CLI, you can use telnet to connect to the switch. While not being the most intuitive, the CLI method is by far the most versatile because it can be used even on "dumb" switches that do not have an IP address assigned to them, and therefore cannot be accessed via other means.Ĭonnecting to Avaya ERS/ Nortel Baystack CLI Avaya Enterprise Routing Switches (formerly Nortel Baystack) 5000 series offer multiple ways of configuring port mirroring, including doing it via the built-in web-interface, Avaya's COM server interface or through CLI (note that SNMP-based Device Manager (JDM) has been decommissioned after Nortel's acquisition by Avaya). Port-mirroring is a powerful tool, especially if used in combination with packet-sniffing utilities such as Snort or Wireshark.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |